In this episode of building the EMG-6 we installed the lower half of the keel assembly. Downloadable Template http://www.electricmotorglider.com/Referance/02-07-00.PDF

In this episode of building the EMG-6 we installed the lower half of the keel assembly.

In this episode of "Building the EMG-6" We position and weld in place the components necessary for the installation of the Upper Keel Assembly

In this episode of Building the EMG-6 we take a quick look at the procedures for installing the Instrument Panel Bulkhead.

In this episode of building the EMG_6 We install the Passenger Rudder Pedal support tube for the fuselage frame

Another video in the series Building the EMG-6. In this episode we experience a design failure in GT-500 Tow Plane during Tow Release testing.

"Building The EMG-6" Instrument Panel Sub Assembly

This is another episode in the Building The EMG-6 Series. In this episode we show how to attach the landing Gear Box to the rest of the fuselage frame.

In this video we are showing the results of our attempt to Aero tow the EMG 6 behind a Quicksilver single place Sport. On a 90°F day 40 hp and 2 pilots each weighing in over 220 pounds the rate of climb was insufficient to be able to continue the flight.

In this short clip we show the EMG-6 landing in no wind conditions using the nose skid as a brake. We had recently changed the main wheel from the larger wheel down to the smaller size will and had made some adjustments to the brake handle but did not quite get it positioned correctly as you can see in the video.

Rookie cameraman (video stabilized)